EGW 10/22 Pic Rail 20 MOA

EGW 10/22 Pic Rail 20 MOA

$39.99

*6061 T6 Extruded Aluminum

*Matte Black

*#6-48 x 1/4 Screws

Quantity
Last items in stock

  Products manufactured and sold by Killough Shooting Sports may require a U.S. Department of State license or a U.S. Department of Commerce license to be exported/shipped out of the United States. Please refer to the Policies link at the bottom of this pag
  Most items ship UPS Ground or USPS. Ammunition is not considered HazMat and does not incur any additional shipping charges but, it must be shipped UPS Ground. Items shipped from the St. Louis Warehouse may be shipped UPS, FedEX, or Spee-Dee ground. Inte
  RETURN POLICYOur goal at Killough Shooting Sports is to offer top notch service and products. If you need to return a product, please see the policies link at the bottom of the page for further instructions. Pay close attention as there are differen
  Prop 65 This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Ruger 10/22 Picatinny Rail 20 MOA

Our Ruger 10-22 mount is made specific to the gun. 

This scope mount will not fit the 10-22 takedown.

*The center spread is the distance between the two middle holes, center to center, on your receiver.

This base sits at approximately 0.4” high.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average. 
Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings. 

Add EGW’s Practical or HD Scope Rings to make it a complete overhaul!

We machine these in our shop using one of our USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.

Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite. 

EGW-46102
2 Items

Specific References