• New

EGW HD CZ 452, 453, 455, 457, 511, 512 For 11mm Picatinny Rail Mount 20 MOA

EGW HD CZ 452, 453, 455, 457, 511, 512 For 11mm Picatinny Rail Mount 20 MOA

$89.99

*Solid 7075 T6 Aircraft Grade Aluminum

*Matte Black

*#6-32 x 3/4 Screws

Quantity

 

Products manufactured and sold by Killough Shooting Sports may require a U.S. Department of State license or a U.S. Department of Commerce license to be exported/shipped out of the United States. Please refer to the Policies link at the bottom of this pag

 

Most items ship UPS Ground or USPS. Ammunition is not considered HazMat and does not incur any additional shipping charges but, it must be shipped UPS Ground. Items shipped from the St. Louis Warehouse may be shipped UPS, FedEX, or Spee-Dee ground. Inte

 

RETURN POLICY Our goal at Killough Shooting Sports is to offer top notch service and products. If you need to return a product, please see the policies link at the bottom of the page for further instructions. Pay close attention as there are differen

 

Prop 65 This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

This mount will fit:
CZ 452
CZ 453
CZ 455
CZ 457 (it is about 1" shorter than the full receiver)
CZ 511
CZ 512
Sako Finnfire M94 S


This base is Right-Handed only.


It is available in 3/8" and 11mm dovetails. Determine which dovetail you have by measuring across the top of the dovetail. If you measure 0.437" you have an 11mm dovetail. If you measure 0.5" you have a 3/8" dovetail.


Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The cross slots are also machined the full width of the mount and gauged to MIL-STD 1913 specs maintaining tolerances of +/-.002".

After machining; the mounts are tumbled and sand blasted. The aluminum mounts are Type III hard coat anodized for long lasting durability. The steel rails are Mil Spec parkerized for a durable rust resistant finish. 

Compatible with Picatinny or Weaver scope rings. Add EGW’s HD Scope Rings to make it a complete package! 

From manufacturing to packaging, EGW’s products are made with pride in the USA.

Installation: EGW recommends 25 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.

EGW-80912
6 Items

Specific References